Cart DB #73: Aladdin Deck Enhancer 1.1

Notes for chip search:

Use "+" as delimeter for all fields (except "cart name", where space is used); if many values are entered, all of them must appear in the cartridge then; case is not sensitive
"Mapper" is the actual mapper used by this cartridge hardware (might not match the one at wiki.nesdev.com, as at the moment I was analyzing this cartridge, there was no mapper assigned to it, so I had to assign my own number for testing)
"Original mapper" is the mapper used by licensed version of this game (for multicarts, it refers to mapper of the inside games, so 0+2 means this cartridge can run NROM+UNROM games)
Order in which you put values doesn't matter (you can write 7400+74138+7400 or 7400+7400+74138 to search for a cartridge that contains at least two 7400 chips and one 74138
Some chips (like PAL16*8) appear in cartridges as 16V8 or 16L8, so be sure to check both posibilities
Same goes for memories - type 27F080 to search for 32 pin memories, 27512 for 28 pin with two chip enables or MASKROM_1M_DIP28 for 28 pin with one chip enable
Same goes for mappers - some examples: AX5904(MMC1), AX5202P(MMC3), PT8154BM (9112MMC3), AX5208C(VRC4), 23C3662(VRC2)
Good news is that you can use wildcards, so 74139+*MMC3* will search for any cartrige that has at least one 74139 and MMC3 chip in any version

Name	Value
U1	6264
U2	CCU_v2.00 CF30288(DIL28)
C1	5.6n
C2	?
C3	?
C4	?
CART1	NES_CART
CON1	ALADDIN CART
D1
D2
D3
D4
L1	?
R1	5R
R2	1k
R3	39k
R4	1k
R5	?
SW1
TR1	?
TR2	?

Name

Value

6264

CCU_v2.00 CF30288(DIL28)

5.6n

CART1

NES_CART

CON1

ALADDIN CART

39k

SW1

TR1

TR2

http://forums.nesdev.com/viewtopic.php?t=19781 Aladdin Deck Enhancer / CCU_v2.00 CF30288 pinouts Basing on the [url=http://forums.nesdev.com/viewtopic.php?t=7937]only existing photos[/url] of Aladdin Deck Enhancer v1.1 I tried to reverse engineer the pinout of cartridge connector as well as CCU_v2.00 CF30288 chip (which should be equivalent in functin to the BF909X chip found in single cartridges) The CIC stun circuit is the same like kevtris [url=http://kevtris.org/mappers/lockout/camerica.html]describes[/url]. Because there exist Aladin cartridges of single games (mapper 71): [url=https://obrazki.elektroda.pl/3461817300_1582418230.jpg][img]https://obrazki.elektroda.pl/3461817300_1582418230_thumb.jpg[/img][/url] and Quattro ones (mapper 232): [url=https://obrazki.elektroda.pl/1599592200_1582418257.jpg][img]https://obrazki.elektroda.pl/1599592200_1582418257_thumb.jpg[/img][/url] I suspect that there is either a pin informing the CCU chip which mapper the cartridge uses or - more likely, according to [url=http://kevtris.org/mappers/camerica/aladdin.html]kevtris description[/url]: [quote] The mapper seems to just be a mix of the BF9093 and BF9096. The two upper address lines from the game ROM goes to a different set of pins depending on wether it's a normal or quattro game. [/quote] there are separate pins for inner bank (INNER3..0) and outer bank (OUTER1..0) and: * single games wire PRG_A17..A14=INNER3..0, skipping OUTER ones * Quattro carts wire PRG_A17..A16=OUTER1..0, PRG_A15..14=INNER1..0 (that would hypthetically allow up to 1MB huge Quattro 4*256kB games to be used) If someone owns Aladdin cart, that would be good to check which aladdin's connector pin goes to one of those ROM pins: 1, 2, 3, 31, 30, 29, 24, 22) If someone owns Aladdin dech enhancer, that would be good to check to which aladdin's connector pin goes one of those CCU pins: 13, 14, 15, 17 [url=https://obrazki.elektroda.pl/2928106200_1582418973_org.jpg][img]https://obrazki.elektroda.pl/2928106200_1582418973_thumb.jpg[/img][/url] [url=https://obrazki.elektroda.pl/1846570700_1582418976_org.jpg][img]https://obrazki.elektroda.pl/1846570700_1582418976_thumb.jpg[/img][/url] [url=https://obrazki.elektroda.pl/8457080900_1582418979_org.jpg][img]https://obrazki.elektroda.pl/8457080900_1582418979_thumb.jpg[/img][/url] [url=https://obrazki.elektroda.pl/6610533800_1582418981.png][img]https://obrazki.elektroda.pl/6610533800_1582418981_thumb.jpg[/img][/url]

Cart name		Notes for chip search: Use "+" as delimeter for all fields (except "cart name", where space is used); if many values are entered, all of them must appear in the cartridge then; case is not sensitive "Mapper" is the actual mapper used by this cartridge hardware (might not match the one at wiki.nesdev.com, as at the moment I was analyzing this cartridge, there was no mapper assigned to it, so I had to assign my own number for testing) "Original mapper" is the mapper used by licensed version of this game (for multicarts, it refers to mapper of the inside games, so 0+2 means this cartridge can run NROM+UNROM games) Order in which you put values doesn't matter (you can write 7400+74138+7400 or 7400+7400+74138 to search for a cartridge that contains at least two 7400 chips and one 74138 Some chips (like PAL168) appear in cartridges as 16V8 or 16L8, so be sure to check both posibilities Same goes for memories - type 27F080 to search for 32 pin memories, 27512 for 28 pin with two chip enables or MASKROM_1M_DIP28 for 28 pin with one chip enable Same goes for mappers - some examples: AX5904(MMC1), AX5202P(MMC3), PT8154BM (9112MMC3), AX5208C(VRC4), 23C3662(VRC2) Good news is that you can use wildcards, so 74139+MMC3* will search for any cartrige that has at least one 74139 and MMC3 chip in any version
Mapper#
Original mapper#
PCB marks
Tags
Chips